User's Manual 322 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
15.9.1 Configuring Skype for Business Server for Presence
On the Skype for Business Server side, you need to define the device in the Skype for Business
Topology as a Trusted Application.
Note:
• Detailed configuration of Skype for Business Server is beyond the scope of this
document.
• Before performing the below procedure, make sure that you have defined the
device in the PSTN Gateway node of the Skype for Business Server Topology
(using the Topology Builder).
Using the Skype for Business Server Management Shell, perform the following steps:
1. Obtain the Site ID
Run the following cmdlet to retrieve the SiteId property of the site:
Get-CsSite
2. Create a Trusted Application Pool
Run the following cmdlet to create a new pool to host the presence application:
New-CsTrustedApplicationPool -Identity <Pool FQDN> -Registrar
<Registrar FQDN> -Site <Site Id>
where:
• Identity is the FQDN of the device, which sends the SIP PUBLISH messages with the
presence status to Skype for Business Server
• Registrar is the FQDN of the Registrar service for the pool
• Site is the Site Id
For example:
To Next Page
Loading...
