AudioCodes Mediant 800B - Multi-Line Extensions and Supplementary Services Parameters; Three-Way Conferencing Parameters

User's Manual 1202 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Call Transfer using re-INVITEs
configure voip > sip-definition
settings > enable-call-transfer-
using-reinvites
[EnableCallTransferUsingReinvites]
Enables call transfer using re-INVITEs.
 [0] Disable = (Default) Call transfer is done using REFER
messages.
 [1] Enable = Call transfer is done by sending re-INVITE
messages (instead of REFER).
Note:
 The device uses two DSP channels per transferred call.
Thus, to use this feature, you also need to configure the
maximum number of available DSP channels, using the
MediaChannels parameter.
 The parameter is applicable only to FXS interfaces.
72.11.5.7 Multi-Line Extensions and Supplementary Services Parameters
The multi-line extensions and supplementary services parameters are described in the
table below.
Table 72-50: Multi-line Extensions and Supplementary Services Parameters
Parameter Description
Supplementary Services Table
Supplementary Services
Table
configure voip >
gateway digital isdn-
supp-serv
[ISDNSuppServ]
Defines phone extension numbers per FXS/BRI port and configures
various supplementary services per endpoint.
The format of the ini file table parameter is as follows:
[ ISDNSuppServ ]
FORMAT ISDNSuppServ_Index = ISDNSuppServ_PhoneNumber,
ISDNSuppServ_LocalPhoneNumber, ISDNSuppServ_Module,
ISDNSuppServ_Port, ISDNSuppServ_UserId,
ISDNSuppServ_UserPassword, ISDNSuppServ_CallerID,
ISDNSuppServ_IsPresentationRestricted,
ISDNSuppServ_IsCallerIDEnabled, ISDNSuppServ_CFB2PhoneNumber,
ISDNSuppServ_CFNR2PhoneNumber,
ISDNSuppServ_CFU2PhoneNumber, ISDNSuppServ_NoReplyTime;
[ \ISDNSuppServ ]
For more information, see 'Configuring Multi-Line Extensions and
Supplementary Services' on page 618.
72.11.5.8 Three-Way Conferencing Parameters
The three-way conferencing parameters are described in the table below.
Table 72-51: Three-Way Conferencing Parameters
Parameter Description
Enable 3-Way Conference
configure voip > gateway dtmf-
supp-service supp-service-
settings > enable-3w-conf
[Enable3WayConference]
Enables the 3-Way Conference feature.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.