AudioCodes Mediant 800B - Voip Interfaces with Multiple Default Gateways; Configuring Static IP Routes

Version 7.2 153 Mediant 800B Gateway & E-SBC
User's Manual 12. Network
3. The NTP application is configured (through the ini file) to serve as OAMP applications:
EnableNTPasOAM = 1
4. DiffServ table:
• Layer-2 QoS values are assigned:
♦ For packets sent with DiffServ value of 46, set VLAN priority to 6
♦ For packets sent with DiffServ value of 40, set VLAN priority to 6
♦ For packets sent with DiffServ value of 26, set VLAN priority to 4
♦ For packets sent with DiffServ value of 10, set VLAN priority to 2
• Layer-3 QoS values are assigned:
♦ For Media Service class, the default DiffServ value is set to 46
♦ For Control Service class, the default DiffServ value is set to 40
♦ For Gold Service class, the default DiffServ value is set to 26
♦ For Bronze Service class, the default DiffServ value is set to 10
12.5.3.4 VoIP Interfaces with Multiple Default Gateways
Below is a configuration example using default gateways per IP network interface. In this
example, the default gateway for OAMP is 192.168.0.1 and for Media and Control it is
200.200.85.1.
Table 12-12: Configured Default Gateway Example
Index
Application
Type
Interface
Mode
IP Address
Prefix
Length
Default
Gateway
Ethernet
Device
Name
0 OAMP
IPv4
Manual
192.168.0.2 16 192.168.0.1 100 Mgmt
1
Media &
Control
IPv4
Manual
200.200.85.14 24 200.200.85.1 200 CntrlMedia
A separate Static Routes table lets you configure static routing rules. Configuring the
following static routing rules enables OAMP applications to access peers on subnet
17.17.0.0 through the gateway 192.168.10.1 (which is not the default gateway of the
interface), and Media & Control applications to access peers on subnet 171.79.39.0
through the gateway 200.200.85.10 (which is not the default gateway of the interface).
Table 12-13: Separate Static Routes Table Example
Destination Prefix Length Gateway Underlying Device
17.17.0.0 16 192.168.10.1 100
171.79.39.0 24 200.200.85.10 200
12.6 Configuring Static IP Routes
The Static Routes table lets you configure up to 30 static IP routing rules. Static routes let
you communicate with LAN networks that are not located behind the Default Gateway that
is specified for an IP network interface in the IP Interfaces table, from which the packets