Version 7.2 1061 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
The parameter is applicable only when the UseWebLogo
parameter is configured to 0.
72.1.3 Telnet Parameters
The Telnet parameters are described in the table below.
Table 72-3: Telnet Parameters
Parameter Description
Embedded Telnet Server
configure system > cli-settings
> telnet
[TelnetServerEnable]
Enables the device's embedded Telnet server. Telnet is disabled by
default for security.
[0] Disable
[1] Enable Unsecured (default)
[2] Enable Secured
Note: Only the primary Web User Account (which has Security
Administration access level) can access the device using Telnet
(see 'Configuring Management User Accounts' on page 79).
Telnet Server TCP Port
configure system > cli-settings
> telnet-port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Telnet Server Idle Timeout
configure system > cli-settings
> idle-timeout
[TelnetServerIdleDisconnect]
Defines the timeout (in minutes) for disconnection of an idle Telnet
session. When set to zero, idle sessions are not disconnected.
The valid range is any value. The default is 0.
Note: For the parameter to take effect, a device reset is required.
Maximum Telnet Sessions
configure system > cli-settings
> telnet-max-sessions
[TelnetMaxSessions]
Defines the maximum number of permitted, concurrent Telnet/SSH
sessions.
The valid range is 1 to 5 sessions. The default is 2.
Note: Before changing the value, make sure that not more than this
number of sessions are currently active; otherwise, the new setting
will not take effect.
[CLIPrivPass] Defines the password to access the Enable configuration mode in
the CLI.
The valid value is a string of up to 50 characters. The default is
"Admin".
Note: The password is case-sensitive.
To Next Page
Loading...
