Version 7.2 83 Mediant 800B Gateway & E-SBC
User's Manual 6. Web-Based Management
Parameter Description
the toolbar) or until the session expires if the user is inactive for a
user-defined duration (see the 'Session Timeout' parameter below).
The valid value is 0 to 5. The default is 2.
Note: Up to five users can be concurrently logged in to the Web
interface.
Session Timeout
session-timeout
[WebUsers_SessionTimeout]
Defines the duration (in minutes) of inactivity of a logged-in user in the
Web interface, after which the user is automatically logged off the
Web session. In other words, the session expires when the user has
not performed any operations (activities) in the Web interface for the
configured timeout duration.
The valid value is 0 to 100000. A value of 0 means no timeout. The
default value is according to the settings of the WebSessionTimeout
global parameter (see 'Configuring Web Session and Access Settings'
on page 84).
Block Duration
block-duration
[WebUsers_BlockTime]
Defines the duration (in seconds) for which the user is blocked when
the user exceeds a user-defined number of failed login attempts.
The valid value is 0 to 100000, where 0 means that the user can do as
many login failures without getting blocked. The default is according to
the settings of the 'Deny Authentication Timer' parameter (see
'Configuring Web Session and Access Settings' on page
84).
Note:
 To enable this feature, see the 'Deny Access On Fail Count'
parameter in 'Configuring Web Session and Access Settings' on
page 84.
 The 'Deny Authentication Timer' parameter relates to failed Web
logins from specific IP addresses.
6.5 Displaying Login Information upon Login
You can enable the device to display login information immediately upon Web login.
 To enable display of user login information upon login:
1. Open the Web Settings page (Setup menu > Administration tab > Web & CLI folder
> Web Settings).
2. Under the Security group, from the 'Display Last Login Information' drop-down list,
select Enable.
3. Click Apply.
To Next Page
Loading...
Need help?
General
