AudioCodes Mediant 800B - HTTP-Based Services

User's Manual 1328 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
[ \CallSetupRules ]
For more information, see 'Configuring Call Setup Rules' on page 426.
72.14.5 HTTP-based Services
The HTTP-based service parameters are described in the table below.
Table 72-82: HTTP-based Service Parameters
Parameter Description
GW Routing Server
configure voip > gw routing
general-setting > gw-routing-
server
[GWRoutingServer]
Enables routing by a Routing server.
 [0] Disable (default)
 [1] Enable
For more information, see Centralized Third-Party Routing Server
on page 294.
Note: The parameter is applicable only to the Gateway
application.
Quality Status
configure system > http-
services > routing-qos-
status
[RoutingServerQualityStatus]
Enables QoS-based routing by the routing server. The device
collects QoS metrics (media and signaling) and sends them to the
routing server.
 [0] Disable (default)
 [1] Enable
For more information, see Configuring QoS-Based Routing by
Routing Server on page 297.
Quality Status Rate
configure system > http-
services > routing-qos-
status-rate
[RoutingServerQualityStatusRate]
Defines the rate (in sec) at which the device sends QoS reports to
the routing server.
The valid range is 15-3600. The default is 60.
For more information, see Configuring QoS-Based Routing by
Routing Server on page 297.
Topology Status
configure system > http-
services > routing-
server-group-status
[RoutingServerGroupStatus]
Enables the reporting of the device's topology status (using the
REST TopologyStatus API command) to HTTP remote hosts.
 [0] Disable (default)
 [1] Enable
For more information, see 'Configuring HTTP Services' on page
288.
Remote Web Services Table
Remote Web Services
configure system > http-services
> http-remote-services
[HTTPRemoteServices]
Defines remote Web services.
The format of the ini file table parameter is as follows:
[HTTPRemoteServices]
FORMAT HTTPRemoteServices_Index =
HTTPRemoteServices_Name, HTTPRemoteServices_Path,
HTTPRemoteServices_HTTPType,
HTTPRemoteServices_Policy,
HTTPRemoteServices_LoginNeeded,
HTTPRemoteServices_PersistentConnection,
HTTPRemoteServices_NumOfSockets,
HTTPRemoteServices_AuthUserName,
HTTPRemoteServices_AuthPassword,
HTTPRemoteServices_TLSContext,