Version 7.2 355 Mediant 800B Gateway & E-SBC
User's Manual 17. Control Network
To facilitate multi-tenant configuration through CLI, you can access a specific tenant "view".
Once in a specific tenant view, all configuration commands apply only to the currently
viewed tenant. Only table rows (indexes) belonging to the viewed tenant can be modified.
New table rows are automatically associated with the viewed tenant (i.e., SRD name). The
display of tables and show running-configuration commands display only rows relevant to
the viewed tenant (and shared tenants). The show commands display only information
relevant to the viewed tenant. To support this CLI functionality, use the following
commands:
To access a specific tenant view:
# srd-view <SRD name>
Once accessed, the tenant's name (i.e., SRD name) forms part of the CLI prompt, for
example:
# srd-view datacenter
(srd-datacenter)#
To exit the tenant view:
# no srd-view
17.2.3 Cloning SRDs
You can clone (duplicate) existing SRDs. This is especially useful when operating in a
multi-tenant environment and you need to add new tenants (SRDs). The new tenants can
quickly and easily be added by simply cloning one of the existing SRDs. Once cloned, all
you need to do is tweak configuration entities associated with the SRD clone.
When an SRD is cloned, the device adds the new SRD clone to the next available index
row in the SRDs table. The SRD clone is assigned a unique name in the following syntax
format: <unique clone ID>_<original SRD index>_CopyOf_<name, or index if no name, of
original SRD>. For example, if you clone SRD "SIP-Trunk" at index 2, the new SRD clone
is assigned the name, "36454371_2_CopyOf_SIP-Trunk".
To Next Page
Loading...
