AudioCodes Mediant 800B - Manipulating Number Prefix

Version 7.2 561 Mediant 800B Gateway & E-SBC
User's Manual 25. Manipulation
Parameter Description
Plans and Type of Number on page 581.
NPI
npi
[NumberPlan]
Defines the Numbering Plan Indicator (NPI).
 [-1] = Not configured and the value received from PSTN/IP is used.
 [0] Unknown (default)
 [1] E.164 Public
 [9] Private
Note:
 The parameter is applicable only to the Destination Phone Number
Manipulation for IP-to-Tel Calls table and Source Phone Number
Manipulation for IP-to-Tel Calls table.
 NPI can be used in the SIP Remote-Party-ID header by using the
EnableRPIHeader and AddTON2RPI parameters.
 For more information on available NPI/TON values, see Numbering
Plans and Type of Number on page 581.
Presentation
is-presentation-restricted
[IsPresentationRestricted]
Enables caller ID.
 Not Configured = Privacy is determined according to the Caller ID
table (see Configuring Caller Display Information on page 636).
 [0] Allowed = Sends Caller ID information when a call is made using
these destination/source prefixes.
 [1] Restricted = Restricts Caller ID information for these prefixes.
Note:
 The parameter is applicable only to the Source Phone Number
Manipulation for IP-to-Tel Calls table and Source Phone Number
Manipulation for Tel-to-IP Calls table.
 If you configure the parameter to Restricted and the 'Asserted
Identity Mode' (AssertedIdMode) parameter to Add P-Asserted-
Identity, the From header in the INVITE message includes the
following:
From: 'anonymous' <sip:
anonymous@anonymous.invalid> and 'privacy: id'
header
25.3 Manipulating Number Prefix
The device supports a notation for adding a prefix where part of the prefix is first extracted
from a user-defined location in the original destination or source number. The notation is
entered in the 'Prefix to Add' field in the Number Manipulation tables (see 'Configuring
Source/Destination Number Manipulation' on page 555): x[n,l]y...