Version 7.2 1073 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
72.2 Networking Parameters
This subsection describes the device's networking parameters.
72.2.1 Ethernet Parameters
The Ethernet parameters are described in the table below.
Table 72-9: Ethernet Parameters
Parameter Description
Physical Ports Table
Physical Ports
configure network >
physical-port
[PhysicalPortsTable]
The table configures the physical Ethernet ports.
The format of the ini file table parameter is as follows:
[ PhysicalPortsTable ]
FORMAT PhysicalPortsTable_Index = PhysicalPortsTable_Port,
PhysicalPortsTable_Mode, PhysicalPortsTable_SpeedDuplex,
PhysicalPortsTable_PortDescription,
PhysicalPortsTable_GroupMember, PhysicalPortsTable_GroupStatus;
[ \PhysicalPortsTable ]
For more information, see Configuring Physical Ethernet Ports on page
138.
Ethernet Groups Table
Ethernet Groups
configure network > ether-
group
[EtherGroupTable]
Defines the transmit (Tx) and receive (Rx) settings for the Ethernet port
groups. The format of the ini file table parameter is:
[EtherGroupTable]
FORMAT EtherGroupTable_Index = EtherGroupTable_Group,
EtherGroupTable_Mode, EtherGroupTable_Member1,
EtherGroupTable_Member2;
[\EtherGroupTable]
For more information, see Configuring Ethernet Port Groups on page
140.
Note: For the parameter to take effect, a device reset is required.
Ethernet Devices table
Ethernet Devices table
configure network >
network-dev
[DeviceTable]
Defines Ethernet Devices (VLANs).
The format of the ini file table parameter is as follows:
[ DeviceTable ]
FORMAT DeviceTable_Index = DeviceTable_VlanID,
DeviceTable_UnderlyingInterface, DeviceTable_DeviceName,
DeviceTable_Tagging; DeviceTable_MTU;
[ \DeviceTable ]
For more information, see Configuring Underlying Ethernet Devices on
page 142.
72.2.2 Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
To Next Page
Loading...
