User's Manual 76 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
6.2.4 Creating a Login Welcome Message
You can create a personalized welcome message that is displayed on the Web Login
screen. The message always begins with the title "Note" and has a color background, as
shown in the example below:
Figure 6-28: Creating Login Welcome Message
 To create a login welcome message:
1. Create an ini file that includes the WelcomeMessage table parameter. Use the
parameter to configure your message, where each index row is a line in your
message, for example:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text;
WelcomeMessage 1 = "*********************************";
WelcomeMessage 2 = "** This is a Welcome message! **";
WelcomeMessage 3 = "*********************************";
[\WelcomeMessage]
2. Load the ini file using the Auxiliary Files page (see Loading Auxiliary Files on page
831).
3. Reset the device with a save-to-flash for your settings to take effect.
 To remove the welcome message:
1. Load an empty ini file, using the Auxiliary Files page.
2. Reset the device with a save-to-flash for your settings to take effect.
6.3 Configuring Additional Management Interfaces
The Additional Management Interfaces table lets you configure up to 16 management
interfaces, in addition to the OAMP management interface in the IP Interfaces table.
Multiple management interfaces lets you access the device's management interfaces (e.g.,
To Next Page
Loading...
Need help?
General
