EasyManuals Logo

AudioCodes Mediant 800B User Manual

AudioCodes Mediant 800B
1338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1091 background imageLoading...
Page #1091 background image
Version 7.2 1091 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
For more information, see Customizing CDRs for SBC Calls on page
990.
72.3.4 Resource Allocation Indication Parameters
The Resource Allocation Indication (RAI) parameters are described in the table below.
Table 72-21: RAI Parameters
Parameter Description
[EnableRAI]
Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured by
the RAIHighThreshold parameter. When enabled and the threshold is
crossed, the device sends the SNMP trap, acBoardCallResourcesAlarm.
[0] = (Default) Disable
[1] = Enable
Note: For the parameter to take effect, a device reset is required.
[RAIHighThreshold]
Defines the high threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of “enabled” endpoints
(trunks are physically connected and synchronized with no alarms and
endpoints are defined in the Trunk Group table).
[RAILowThreshold]
Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this low
threshold, the device sends an SNMP acBoardCallResourcesAlarm
alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default is 90%.
[RAILoopTime]
Defines the time interval (in seconds) that the device periodically checks
call resource availability.
The valid range is 1 to 200. The default is 10.
72.3.5 PacketSmart Parameters
The PacketSmart parameters are described in the table below. For more information on
PacketSmart, see 'Configuring PacketSmart for Network Monitoring' on page 943.
Table 72-22: PacketSmart Parameters
Parameter Description
PacketSmart Agent Mode
configure system >
packetsmart enable
Enables the embedded PacketSmart agent.
[0] Disable (Default)
[1] Enable

Table of Contents

Other manuals for AudioCodes Mediant 800B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant 800B and is the answer not in the manual?

AudioCodes Mediant 800B Specifications

General IconGeneral
BrandAudioCodes
ModelMediant 800B
CategoryGateway
LanguageEnglish

Related product manuals