User's Manual 1090 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
logging settings > dbg-rec-
dest-ip
[DebugRecordingDestIP]
Debug Recording Destination
Port
configure troubleshoot >
logging settings > dbg-rec-
dest-port
[DebugRecordingDestPort]
Defines the UDP port of the server for capturing debug recording.
The default is 925.
Enable Core Dump
[EnableCoreDump]
Enables the automatic generation of a Core Dump file upon a device
crash.
ï‚§ [0] Disable (default)
ï‚§ [1] Enable
Note: For the parameter to take effect, a device reset is required.
Core Dump Destination IP
[CoreDumpDestIP]
Defines the IP address of the remote server where you want the
device to send the Core Dump file.
By default, no IP address is defined.
Logging Filters Table
Logging Filters Table
configure troubleshoot >
logging logging-filters
[LoggingFilters]
The table defines log filtering rules for Syslog messages and debug
recordings.
The format of the ini file table parameter is:
[ LoggingFilters ]
FORMAT LoggingFilters_Index = LoggingFilters_FilterType,
LoggingFilters_Value, LoggingFilters_LogDestination,
LoggingFilters_CaptureType, LoggingFilters_Mode;
[ \LoggingFilters ]
For more information, see 'Configuring Log Filter Rules' on page
1007.
Gateway CDR Format Table
Gateway CDR Format
configure troubleshoot > cdr >
cdr-format gw-cdr-format
[GWCDRFormat]
The table defines CDR customization rules for Gateway calls.
The format of the ini file table parameter is:
[ GWCDRFormat ]
FORMAT GWCDRFormat_Index = GWCDRFormat_CDRType,
GWCDRFormat_FieldType, GWCDRFormat_Title,
GWCDRFormat_RadiusType, GWCDRFormat_RadiusID;
[ \GWCDRFormat ]
For more information, see Customizing CDRs for Gateway Calls on
page 986.
SBC CDR Format Table
SBC CDR Format Table
configure troubleshoot > cdr >
cdr-format sbc-cdr-format
[SBCCDRFormat]
The table defines CDR customization rules for SBC calls.
The format of the ini file table parameter is:
[ SBCCDRFormat ]
FORMAT SBCCDRFormat_Index = SBCCDRFormat_CDRType,
SBCCDRFormat_FieldType, SBCCDRFormat_Title,
SBCCDRFormat_RadiusType, SBCCDRFormat_RadiusID;
[ \SBCCDRFormat ]