AudioCodes Mediant 800B - CAS Parameters

Version 7.2 1223 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
TDMBusPSTNAutoClockEnable parameter is set to 1.
72.11.6.3 CAS Parameters
The Common Channel Associated (CAS) parameters are described in the table below.
Note: CAS is applicable only to ISDN PRI interfaces.
Table 72-60: CAS Parameters
Parameter Description
[CASOrientedBoard] Enables DSP resource allocation for CAS.
 [0] = (Default) Disable.
 [1] = Enable.
Note:
 For the parameter to take effect, a device reset is
required.
 Enable the parameter before configuring CAS.
CAS Transport Type
cas-transport-type
[CASTransportType]
Determines the ABCD signaling transport type over IP.
 [0] CAS Events Only = (Default) Disable CAS relay.
 [1] CAS RFC2833 Relay = Enable CAS relay mode
using RFC 2833.
The CAS relay mode can be used with the TDM
tunneling feature to enable tunneling over IP for both
voice and CAS signaling bearers.
[CASAddressingDelimiters] Enables the addition of delimiters to the received
address or received ANI digits string.
 [0] = (default) Disable. The address and ANI strings
remain without delimiters.
 [1] = Enable. Delimiters such as '*', '#', and 'ST' are
added to the received address or received ANI digits
string.
configure voip > interface e1-t1 > cas-
delimiters-types
[CASDelimitersPaddingUsage]
Defines the digits string delimiter padding usage per
trunk.
 [0] = (Default) Default address string padding:
'*XXX#' (where XXX is the digit string that begins
with '*' and ends with '#', when using padding).
 [1] = Special use of asterisks delimiters:
'*XXX*YYY*' (where XXX is the address, YYY is the
source phone number, and '*' is the only delimiter
padding).
Note:
For the parameter to take effect, a device reset is
required.