AudioCodes Mediant 800B - RADIUS and LDAP Parameters; General Parameters

Version 7.2 1321 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
SIP Recording Rules
configure voip > sip-definition
sip-recording sip-rec-routing
[SIPRecRouting]
Defines SIP Recording Routing rules (for siprec).
The format of the ini file table parameter is as follows:
[ SIPRecRouting ]
FORMAT SIPRecRouting_Index =
SIPRecRouting_RecordedIPGroupName,
SIPRecRouting_RecordedSourcePrefix,
SIPRecRouting_RecordedDestinationPrefix,
SIPRecRouting_PeerIPGroupName,
SIPRecRouting_PeerTrunkGroupID, SIPRecRouting_Caller,
SIPRecRouting_SRSIPGroupName,
SIPRecRouting_SRSRedundantIPGroupName;
[ \SIPRecRouting ]
For more information, see 'Configuring SIP Recording Rules' on
page 242.
72.14.2 RADIUS and LDAP Parameters
72.14.2.1 General Parameters
The general RADIUS and LDAP parameters are described in the table below.
Table 72-77: General RADIUS and LDAP Parameters
Parameter Description
Use Local Users Database
configure system > mgmt-auth
> use-local-users-db
[MgmtUseLocalUsersDatabase]
Defines when the device uses the Local Users table or an
LDAP/RADIUS server for authenticating the login credentials
(username-password) of users when logging into the device's
management interface (e.g., Web or CLI).
 [0] When No Auth Server Defined = (Default) The device
authenticates the users using the Local Users table in the
following scenarios:

If no LDAP/RADIUS server is configured.

If an LDAP/RADIUS server is configured, but connectivity
with the server is down. If there is connectivity with the
server, the device uses the server to authenticate the user.
 [1] Always = The device first attempts to authenticate the user
using the Local Users table. If no user is found (based on the
username-password combination), it attempts to authenticate
the user using the LDAP/RADIUS server.
Behavior upon Authentication
Server Timeout
configure system > mgmt-auth
> timeout-behavior
[MgmtBehaviorOnTimeout]
Defines the device's response when a connection timeout occurs
with the LDAP/RADIUS server.
 [0] Deny Access = User is denied access to the management
platform.
 [1] Verify Access Locally = (Default) Device verifies the user's
credentials in its Local Users table (local database).
Note: The parameter is applicable to LDAP- and RADIUS-based
management-user login authentication.
Default Access Level Defines the default access level for the device when the
LDAP/RADIUS response doesn't include an access level attribute