AudioCodes Mediant 800B - Triggers for Automatic Update

Version 7.2 885 Mediant 800B Gateway & E-SBC
User's Manual 51. Automatic Provisioning
File Type
Keywords for
Template File
Value Replacing
<FILE> Placeholder
CLI Script file cli cliScript.txt
CLI Startup Script file clis cliStartupScript.txt
CMP file based on timestamp acmp autoFirmware.cmp
User Info file usrinf userInfo.txt
CMP file cmp firmware.cmp
Feature Key file fk fk.ini
Call Progress Tone (CPT) file cpt cpt.dat
Prerecorded Tones (PRT) file prt prt.dat
CAS file cas cas.dat
Dial Plan file dpln dialPlan.dat
Answering Machine Detection (AMD)
file
amd amd.dat
SSL/TLS Private Key file sslp
pkey.pem
pkey<ID>.pem (for multi-certificate
system)
SSL/TLS Root Certificate file sslr
root.pem
root<ID>.pem (for multi-certificate
system)
SSL/TLS Certificate file sslc
cert.pem
cert<ID>.pem (for multi-certificate
system)
51.2.5 Triggers for Automatic Update
The Automatic Update feature can be triggered by the following:

Upon device startup (reset or power up). To disable this trigger, run the following CLI
command:
(config-system)# automatic-update
(automatic-update)# run-on-reboot off

Periodically:
• Specified time of day (e.g., 18:00), configured by the ini file parameter
AutoUpdatePredefinedTime or CLI command configure system > automatic-
update > predefined-time.
• Interval between Automatic Updates (e.g., every 60 minutes), configured by the
ini file parameter AutoUpdateFrequency or CLI command configure system >
automatic-update > update-frequency.

Centralized provisioning server request:
• Upon receipt of an SNMP request from the provisioning server.
• Upon receipt of a special SIP NOTIFY message from the provisioning server. The
NOTIFY message includes an Event header with the AudioCodes proprietary
value, "check-sync;reboot=false", as shown in the example below: