AudioCodes Mediant 800B - Web Parameters

User's Manual 1056 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Access List Table
configure network >
access-list
[WebAccessList_x]
This table configures up to ten IP addresses that are permitted to
access the device's Web interface and Telnet interfaces. Access
from an undefined IP address is denied. When no IP addresses are
defined in this table, this security feature is inactive (i.e., the device
can be accessed from any IP address).
The default is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For a description of the parameter, see 'Configuring Web and Telnet
Access List' on page 87.
Local Users Table
Local Users
configure system >
user
[WebUsers]
The table defines management users.
The format of the ini file table parameter is as follows:
[ WebUsers ]
FORMAT WebUsers_Index = WebUsers_Username,
WebUsers_Password, WebUsers_Status, WebUsers_PwAgeInterval,
WebUsers_SessionLimit, WebUsers_SessionTimeout,
WebUsers_BlockTime, WebUsers_UserLevel, WebUsers_PwNonce,
WebUsers_SSHPublicKey;
[ \WebUsers ]
For more information, see Configuring Management User Accounts on
page 79.
Additional Management Interfaces Table
Additional Management
Interfaces
configure system >
additional-mgmt-if
[AdditionalManagementInterf
aces]
The table defines additional management interfaces.
The format of the ini file table parameter is as follows:
[ AdditionalManagementInterfaces ]
FORMAT AdditionalManagementInterfaces_Index =
AdditionalManagementInterfaces_InterfaceName,
AdditionalManagementInterfaces_TLSContextName,
AdditionalManagementInterfaces_HTTPSOnly;
[ \AdditionalManagementInterfaces ]
For more information, see Configuring Additional Management
Interfaces on page 76.
72.1.2 Web Parameters
The Web parameters are described in the table below.
Table 72-2: Web Parameters
Parameter Description
Enable web access from all interfaces
web-access-from-all-interfaces
[EnableWebAccessFromAllInterfaces]
Enables Web access from any of the device's IP network
interfaces. The feature applies to HTTP and HTTPS
protocols.
 [0] = (Default) Disable – Web access is only through the
OAMP interface.
 [1] = Enable - Web access is through any network