Version 7.2 1057 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
Note:
For the parameter to take effect, a device reset is
required.
Instead of using this parameter, you can use the
Additional Management Interfaces table to assign
specific IP network interfaces for management interfaces
(as well as assign them TLS Contexts). For more
information, see Configuring Additional Management
Interfaces on page
76.
Password Change Interval
[WebUserPassChangeInterval]
Defines the duration (in minutes) of the validity of Web login
passwords. When this duration expires, the password of the
Web user must be changed.
The valid value is 0 to 100000, where 0 means that the
password is always valid. The default is 1140.
Note: The parameter is applicable only when using the
Local Users table, where the default value of the 'Password
Age' parameter in the Local Users table inherits the
parameter's value.
User Inactivity Timer
[UserInactivityTimer]
Defines the duration (in days) for which a user has not
logged in to the Web interface, after which the status of the
user becomes inactive and can no longer access the Web
interface. These users c
an only log in to the Web interface if
their status is changed (to New or Valid) by a Security
Administrator or Master user.
The valid value is 0 to 10000, where 0 means inactive. The
default is 90.
Note: The parameter is applicable only when using the
Local Users table.
Session Timeout
[WebSessionTimeout]
Defines the duration (in minutes) of inactivity of a logged-in
user in the Web interface, after which the user is
automatically logged off the Web session. In other words,
the session expires when the user has not performed any
operations (activities) in the Web interface for the
configured duration.
The valid value is 0-100000, where 0 means no timeout.
The default is 15.
Note: You can also configure the functionality per user in
the Local Users table (see 'Configuring Management User
Accounts' on page 79), which overrides this global setting.
Deny Access On Fail Count
[DenyAccessOnFailCount]
Defines the maximum number of failed login attempts, after
which the requesting IP address is blocked.
The valid value range is 0 to 10. The values 0 and 1 mean
immediate block. The default is 3.
Deny Authentication Timer
[DenyAuthenticationTimer]
Defines the duration (in seconds) for which login to the Web
interface is denied from a specific IP address (for all users)
when the number of failed login attempts has exceeded the
maximum. This maximum is defined by the
DenyAccessOnFailCount parameter. Only after this time
expires can users attempt to login from this same IP
To Next Page
Loading...
