AudioCodes Mediant 800B - Automatic Update Parameters

User's Manual 1068 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
[PrerecordedTonesFileName]
Note:
 For the parameter to take effect, a device reset is required.

CAS File
[CASFileName_x]
Defines the CAS file name (e.g., 'E_M_WinkTable.dat'), which defines
the CAS protocol (where x denotes the CAS file ID 0 to 7). It is
possible to define up to eight different CAS files by repeating the
parameter. Each CAS file can be associated with one or more of the
device's trunks, using the parameter CASTableIndex or it can be
associated per B-channel using the parameter CASChannelIndex.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'cas_us.dat'.
Note: For the parameter to take effect, a device reset is required.
Dial Plan
[CasTrunkDialPlanName_x]
Defines the Dial Plan name (up to 11-character strings) per trunk.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'dial_plan_2.dat'.
Note: The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Dial Plan File
[DialPlanFileName]
Defines the name of the Dial Plan file. This file should be created
using AudioCodes DConvert utility (refer to DConvert Utility User's
Guide).
For the ini file, the name must be enclosed by single apostrophes, for
example, 'dial_plan.dat'.
[UserInfoFileName] Defines the name of the file containing the User Information data.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'userinfo_us.dat'.
72.1.8 Automatic Update Parameters
The automatic update of software and configuration files parameters are described in the
table below.
Table 72-8: Automatic Update of Software and Configuration Files Parameters
Parameter Description
General Automatic Update Parameters
CLI path: configure system > automatic-update
update-firmware
[AutoUpdateCmpFile]
Enables the Automatic Update mechanism for the cmp file.
 [0] = (Default) The Automatic Update mechanism doesn't apply to
the cmp file.
 [1] = The Automatic Update mechanism includes the cmp file.
Note: For the parameter to take effect, a device reset is required.
update-frequency
[AutoUpdateFrequency]
Defines the interval (in minutes) that the device waits between
consecutive automatic updates.
The default is 0 (i.e., the update at fixed intervals mechanism is
disabled).
Note: For the parameter to take effect, a device reset is required.