Version 7.2 847 Mediant 800B Gateway & E-SBC
User's Manual 47. Auxiliary Files
47.6.6 Viewing Information of Installed Dial Plan File
You can view information about the Dial Plan file currently installed on the device, through
the device's CLI:
Viewing Dial Plan file information: You can view the file name of the installed Dial
Plan file and the names of the Dial Plans defined in the Dial Plan file, by entering the
following CLI command (in Enable mode):
# debug auxilary-files dial-plan info
For example, the following shows the file name of the installed Dial Plan file and lists
its Dial Plans:
# debug auxilary-files dial-plan info
File Name: MyDialPlan.txt
Plans:
Plan #0 = PLAN1
Plan #1 = PLAN2
Note that the index number of the first Dial Plan is 0.
Searching a prefix number: You can check whether a specific prefix number is
defined in a specific Dial Plan (and view the corresponding tag if the Dial Plan
implements tags), by entering the following CLI command (in Enable mode):
# debug auxilary-files dial-plan match-number <Dial Plan
number> <prefix number>
For example, the following checks whether the called prefix number 2000 is defined in
Dial Plan 1, which is used for obtaining the destination IP address (tag):
# debug auxilary-files dial-plan match-number PLAN1 2000
Match found for 4 digits
Matched prefix: 2000
Tag: 10.33.45.92
47.7 User Information File
This section describes the User Info table.
47.7.1 Enabling the User Info Table
Before you can use the User Info table, you need to enable the User Info functionality, as
described in the following procedure.
To enable the User Info table:
1. Make sure that your device's License Key provides far-end users support ("FEU"). To
view the License Key, see 'Viewing the License Key' on page 864.
2. Open the Proxy & Registration page (Setup menu > Signaling & Media tab > SIP
Definitions folder > Proxy & Registration).
3. From the 'Enable User-Information Usage' drop-down list (EnableUserInfoUsage),
select Enable:
Figure 47-5: Enabling User Info Table
To Next Page
Loading...
Need help?
General
