Version 7.2 861 Mediant 800B Gateway & E-SBC
User's Manual 48. License Key
Note: The License Key installation process includes a device reset and is therefore,
traffic-affecting. To minimize the disruption of current calls, it is recommended to
perform this procedure during periods of low traffic.
To install a License Key file for standalone devices through Web interface:
1. Open the License Key page (see Viewing the License Key on page 857).
2. Back up the currently installed License Key, as a precaution. If the new License Key
does not comply with your requirements, you can re-load this backed-up License Key
to restore the device's original capabilities. For backing up the License Key, see
Backing up the License Key on page 867.
3. Click the Load By File button, navigate to the License Key file on your computer, and
then select the file to load to the device; the Apply New License Key button appears.
The License Key page uses color-coded icons to indicate the changes between the
previous License Key and the newly loaded License Key (for more information, see
Installing License Key through Web Interface on page 864).
Note: If want to cancel installation, reset the device without a save to flash. For more
information, see Resetting the Device on page 821.
4. Click Apply New License Key; the following message box appears:
Figure 48-7: Apply New License Key Message
5. Click Reset; the device begins to save the file to flash memory with a reset and the
following progress message box appears:
Figure 48-8: Reset in Progress for License Key
To Next Page
Loading...
