Version 7.2 1191 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
the Caller ID signal doesn't change the distinctive ringing
timing.
 For the parameter to take effect, a device reset is required.
configure voip > interface fxs-fxo >
bellcore-callerid-type-one-sub-
standard
[BellcoreCallerIDTypeOneSubSta
ndard]
Determines the Bellcore Caller ID sub-standard.
 [0] = (Default) Between rings.
 [1] = Not ring related.
Note:
 For the parameter to take effect, a device reset is required.
 The parameter is applicable only to FXS interfaces.
configure voip > interface fxs-fxo >
etsi-callerid-type-one-sub-
standard
[ETSICallerIDTypeOneSubStanda
rd]
Determines the ETSI FSK Caller ID Type 1 sub-standard (FXS
only).
 [0] = (Default) ETSI between rings.
 [1] = ETSI before ring DT_AS.
 [2] = ETSI before ring RP_AS.
 [3] = ETSI before ring LR_DT_AS.
 [4] = ETSI not ring related DT_AS.
 [5] = ETSI not ring related RP_AS.
 [6] = ETSI not ring related LR_DT_AS.
Note:
 For the parameter to take effect, a device reset is required.
 The parameter is applicable only to FXS interfaces.
Asserted Identity Mode
asserted-identity-m
[AssertedIdMode]
Determines whether the SIP header P-Asserted-Identity or P-
Preferred-Identity is added to the sent INVITE, 200 OK, or
UPDATE request for Caller ID (or privacy). These headers are
used to present the calling party's Caller ID, which is composed
of a Calling Number and a Calling Name (optional).
 [0] Disabled = (Default) P-Asserted-Identity and P-Preferred-
Identity headers are not added.
 [1] Add P-Asserted-Identity
 [2] Add P-Preferred-Identity
The used header also depends on the calling Privacy (allowed or
restricted). These headers are used together with the Privacy
header. If Caller ID is restricted (i.e., P-Asserted-Identity is not
sent), the Privacy header includes the value 'id' ('Privacy: id').
Otherwise, for allowed Caller ID, 'Privacy: none' is used. If Caller
ID is restricted (received from Tel or configured in the device),
the From header is set
to <anonymous@an
onymous.inv
alid>.
For Digital Interfaces: The 200 OK response can contain the
connected party CallerID - Connected Number and Connected
Name. For example, if the call is answered by the device, the
200 OK response includes the P-Asserted-
The device interworks (in some ISDN variants), the Connected
Party number and name from Q.931 Connect message to SIP
200 OK with the P-Asserted-Identity header. In the opposite
direction, if the ISDN device receives a 200 OK with P-Asserted-
Identity header, it interworks it to the Connected party number
and name in the Q.931 Connect message, including its privacy.
Use Destination As Connected Enables the device to include the Called Party Number, from
outgoing Tel calls (after number manipulation), in the SIP P-
To Next Page
Loading...
Need help?
General
