User's Manual 540 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
2. Click New; the following dialog box appears:
Figure 24-4: Routing Policies Table - Edit Dialog Box
3. Configure the Routing Policy rule according to the parameters described in the table
below.
4. Click Apply.
Table 24-5: Routing Policies Table Parameter Descriptions
Parameter Description
Index
[GwRoutingPolicy_Index]
(Read-only) Displays the index number of the table
row.
Name
name
[GWRoutingPolicy_Name]
Defines a descriptive name, which is used when
associating the row in other tables.
The valid value is a string of up to 40 characters. The
default value is "GwRoutingPolicy".
LDAP Servers Group Name
ldap-srv-group-name
[GWRoutingPolicy_LdapServersGroupName]
Assigns an LDAP Server Group to the Routing Policy.
IP-to-Tel and Tel-to-IP routing rules that require
LDAP-
based routing (and/or Call Setup Rules) use the
LDAP server(s) assigned to the LDAP Server Group.
By default, no value is defined.
For more information on LDAP Server Groups, see
'Configuring LDAP Server Groups' on page 256.
LCR Feature
lcr-enable
[GWRoutingPolicy_LCREnable]
Enables the Least Cost Routing (LCR) feature for the
Routing Policy.
[0] Disable (default)
[1] Enable
For more information on LCR, see 'Least Cost
Routing' on page 283.
Note: LCR is applicable only to Tel-to-IP routing.
To Next Page
Loading...
