Version 7.2 1053 Mediant 800B Gateway & E-SBC
User's Manual 71. Dialing Plan Notation for Routing and Manipulation
Notation Description
Special ASCII
Characters
The device does not support the use of ASCII characters in manipulation
rules and therefore, for LDAP-based queries, the device can use the
hexadecimal (HEX) format of the ASCII characters for phone numbers
instead. The HEX value must be preceded by a backslash “\”. For example,
you can configure a manipulation rule that changes the received number
+49 (7303) 165-xxxxx to +49 \287303\29 165-xxxxx, where \28 is the
ASCII HEX value for “(“ and \29 is the ASCII HEX value for “)”. The
manipulation rule in this example would denote the parenthesis in the
destination number prefix using "x" wildcards (e.g., xx165xxxxx#); the prefix
to add to the number would include the HEX values (e.g., +49 \287303\29
165-).
Below is a list of common ASCII characters and their corresponding HEX
values:
ASCII Character HEX Value
* \2a
( \28
) \29
\ \5c
/ \2f
To Next Page
Loading...
