AudioCodes Mediant 800B - Page 1087

Version 7.2 1087 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
Files
configure troubleshoot > cdr >
local-storage-max-files
[CDRLocalMaxNomOfFiles]
number is reached, the device replaces (overwrites) the oldest
created file with a subsequent new file, and so on.
The valid value is 2 to 4096. The default is 5.
Local Storage File Creation
Interval
configure troubleshoot > cdr >
local-storage-interval
[CDRLocalInterval]
Defines how often (in minutes) the device creates a new CDR file.
For example, if configured to 60, it creates a new file every hour. This
occurs even if the maximum configured file size has not been
reached (see the CDRLocalMaxFileSize parameter). However, if the
maximum configured file size has been reached and the interval
configured by the parameter has not been reached, a new CDR file
is created.
The valid value is 2 to 1440. The default is 60.
Debug Level
configure troubleshoot >
syslog > debug-level
[GwDebugLevel]
Enables Syslog debug reporting and logging level.
 [0] No Debug = (Default) Debug is disabled and Syslog
messages are not sent.
 [1] Basic = Sends debug logs of incoming and outgoing SIP
messages.
 [5] Detailed = Sends debug logs of incoming and outgoing SIP
message as well as many other logged processes.
configure system > cdr > non-
call-cdr-rprt
[EnableNonCallCdr]
Enables creation of CDR messages for non-call SIP dialogs (such as
SUBSCRIBE, OPTIONS, and REGISTER).
 [0] = (Default) Disable
 [1] = Enable
Note: The parameter is applicable only to the SBC application.
Syslog Optimization
configure troubleshoot >
syslog > syslog-optimization
[SyslogOptimization]
Enables the device to accumulate and bundle multiple debug
messages into a single UDP packet and then send it to a Syslog
server. The benefit of this feature is that it reduces the number of
UDP Syslog packets, thereby improving (optimizing) CPU utilization.
 [0] Disable
 [1] Enable (default)
Note: The size of the bundled message is configured by the
MaxBundleSyslogLength parameter.
mx-syslog-lgth
[MaxBundleSyslogLength]
Defines the maximum size (in bytes) threshold of logged Syslog
messages bundled into a single UDP packet, after which they are
sent to a Syslog server.
The valid value range is 0 to 1220 (where 0 indicates that no
bundling occurs). The default is 1220.
Note: The parameter is applicable only if the GWDebugLevel
parameter is enabled.
Syslog CPU Protection
configure troubleshoot >
syslog > syslog-cpu-protection
[SyslogCpuProtection]
Enables the protection of the device's CPU resources during debug
reporting, ensuring voice traffic is unaffected. If CPU resources drop
(i.e., high CPU usage) to a critical level (threshold), the device
automatically lowers the debug level to free up CPU resources that
were required for the previous debug-level functionality. When
sufficient CPU resources become available again, the device
increases the debug level. The threshold is configured by the 'Debug
Level High Threshold' parameter (see below).

[0]
Disable