AudioCodes Mediant 800B - Page 1180

User's Manual 1180 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Table 72-42: Digit Collection and Dial Plan Parameters
Parameter Description
Dial Plan Index
configure voip > gateway dtmf-supp-
service dtmf-and-dialing > dial-plan-
index
[DialPlanIndex]
Defines the Dial Plan index to use in the external Dial Plan
file. The Dial Plan file is loaded to the device as a .dat file
(converted using the DConvert utility). The D
ial Plan index can
be defined globally or per Tel Profile.
The valid value range is 0 to 7, where 0 denotes PLAN1, 1
denotes PLAN2, and so on. The default is -1, indicating that
no Dial Plan file is used.
Note:
 If the parameter is configured to select a Dial Plan index,
the settings of the parameter DigitMapping are ignored.
 If the parameter is configured to select a Dial Plan index
from an external Dial Plan file, the device first attempts to
locate a matching digit pattern in the Dial Plan file, and if
not found, then attempts to locate a matching digit pattern
in the Digit Map rules configured by the DigitMapping
parameter.
 The parameter is also applicable to ISDN with overlap
dialing.
 For E1 CAS MFC-R2 variants (which don't support
terminating digit for the called party number, usually I-15),
the parameter and the DigitMapping parameter are
ignored. Instead, you can define a Dial Plan template per
trunk using the parameter CasTrunkDialPlanName_x (or in
the Trunk Settings page).
 The parameter can also be configured in a Tel Profile.
 For more information on the Dial Plan file, see 'Dialing
Plans for Digit Collection' on page 840.
configure voip > gateway
manipulation settings > tel2ip-src-nb-
map-dial-index
[Tel2IPSourceNumberMappingDialPl
anIndex]
Defines the Dial Plan index in the external Dial Plan file for the
Tel-to-IP Source Number Mapping feature.
The valid value range is 0 to 7, defining the Dial Plan index
[Plan x] in the Dial Plan file. The default is -1 (disabled).
For more information on this feature, see 'Modifying ISDN-to-
IP Calling Party Number using Dial Plan File' on page 845.
Digit Mapping Rules
configure voip > gateway dtmf-supp-
service dtmf-and-dialing >
digitmapping
[DigitMapping]
Defines the digit map pattern (used to reduce the dialing
period when ISDN overlap dialing for digital interfaces). If the
digit string (i.e., dialed number) matches one of the patterns in
the digit map, the device stops collecting digits and
establishes a call with the collected number.
The digit map pattern can contain up to 52 options (rules),
each separated by a vertical bar (|). The maximum length of
the entire digit pattern is 152 characters. The available
notations include the following:
 [n-m]: Range of numbers (not letters).
 . (single dot): Repeat digits until next notation (e.g., T).
 x: Any single digit.
 T: Dial timeout (configured by the TimeBetweenDigits
parameter).
 S: Short timer (configured by the TimeBetweenDigits
parameter; default is two seconds) that can be used when
a specific rule is defined after a more general rule. For