AudioCodes Mediant 800B - Page 1225

Version 7.2 1225 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
CASFILENAME_0='E_M_FGBWinkTable.dat'
CASFILENAME_1='E_M_FGDWinkTable.dat'
CASFILENAME_2='E_M_WinkTable.txt'
CasChannelIndex_5 =
‘0,0,0,1,1,1,2,2,2,0,0,0,1,1,1,0,1,2,0,
2,1,2,2,2’
CASDelimitersPaddingUsage_5 = 1
 CAS table per channel group:
Each channel group
is separated by a colon and each channel is
separated by a comma. The syntax is <x-y channel
range>:<CAS table index>, (e.g., "1-10:1,11-31:3").
Every B-channel (including 16 for E1) must belong
to a channel group. Below is an example for
configuring an E1 CAS trunk (Trunk 5) with several
CAS variants:
ProtocolType_5 = 8
CASFILENAME_2='E1_R2D'
CASFILENAME_7= E_M_ImmediateTable_A-
Bit.txt'
CasChannelIndex_5 = ‘1-10:2,11-20:7,21-
31:2’
Note:
 To configure the parameter, the trunk must first be
stopped.
 Only one of these formats can be implemented; not
both.
 When the parameter is not configured, a single CAS
table for the entire trunk is used, configured by the
parameter CASTableIndex.
[CASTablesNum]
Defines how many CAS protocol configurations files are
loaded.
The valid range is 1 to 8.
Note: For the parameter
to take effect, a device reset is
required.
CAS State Machines Parameters
Note: To configure the CAS State Machine table using the Web interface, see '
Configuring CAS State
Machines' on page 497. The CAS state machine can be configured only through the Web-based
management tool.
Generate Digit On Time
[CASStateMachineGenerateDigitOnTime]
Generates digit on-time (in msec).
The value must be a positive value. The default is -1.
Generate Inter Digit Time
[CASStateMachineGenerateInterDigitTime]
Generates digit off-time (in msec).
The value must be a positive value. The default is -1.
DTMF Max Detection Time
[CASStateMachineDTMFMaxOnDetectionT
ime]
Detects digit maximum on time (according to DSP
detection information event) in msec units.
The value must be a positive value. The default is -1.
DTMF Min Detection Time
[CASStateMachineDTMFMinOnDetectionTi
me]
Detects digit minimum on time (according to DSP
detection information event) in msec units. The digit
time length must be longer than this value to receive a
detection. Any number may be used, but the value