Version 7.2 1245 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
AoC Support
configure voip > gateway
dtmf-supp-service supp-
service-settings > aoc-
support
[EnableAOC]
Enables the interworking of ISDN Advice of Charge (AOC) messages
to SIP.
[0] Disable (default)
[1] Enable
For more information on AOC, see 'Advice of Charge Services for
Euro ISDN' on page 623.
Add IE in SETUP
add-ie-in-setup
[AddIEinSetup]
Global parameter that defines an optional Information Element (IE)
data (in hex format) to add to ISDN Setup messages. You can also
configure this functionality per specific calls, using IP Profiles
(IpProfile_AddIEInSetup). For a detailed description of the parameter
and for configuring this functionality in the IP Profiles table, see
'Configuring IP Profiles' on page 436.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.
Trunk Groups to Send IE
trkgrps-to-snd-ie
[SendIEonTG]
Defines Trunk Group IDs (up to 50 characters) from where the
optional ISDN IE (defined by the parameter AddIEinSetup) is sent.
For example: '1,2,4,10,12,6'.
Note:
You can configure different IE data for Trunk Groups by defining
the parameter for different IP Profile IDs (using the parameter
IPProfile), and then assigning the required IP Profile ID in the IP-
to-Tel Routing table (PSTNPrefix).
When IP Profiles are used for configuring different IE data for
Trunk Groups, the parameter is ignored.
Enable User-to-User IE for
Tel to IP
uui-ie-for-tel2ip
[EnableUUITel2IP]
Enables transfer of User-to-User (UU) IE from ISDN to SIP.
[0] Disable (default)
[1] Enable
The device supports the following ISDN-to-SIP interworking: Setup to
SIP INVITE, Connect to SIP 200 OK, User Information to SIP INFO,
Alerting to SIP 18x response, and Disconnect to SIP BYE response
messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS ISDN variants.
Enable User-to-User IE for IP
to Tel
uui-ie-for-ip2tel
[EnableUUIIP2Tel]
Enables interworking of SIP user-to-user information (UUI) to User-to-
User IE in ISDN Q.931 messages.
[0]
Disable = (Default) Received UUI is not sent in ISDN message.
[1] Enable = The device interworks UUI from SIP to ISDN
messages. The device supports the following SIP-to-ISDN
interworking of UUI:
SIP INVITE to Q.931 Setup
SIP REFER to Q.931 Setup
SIP 200 OK to Q.931 Connect
SIP INFO to Q.931 User Information
SIP 18x to Q.931 Alerting
SIP BYE to Q.931 Disconnect
Note:
The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS ISDN variants.
To Next Page
Loading...
