Version 7.2 1279 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
file used).
For more information on this feature, see Dial Plan Prefix Tags
for IP-to-Tel Routing on page 843.
Note: The parameter is applicable only to digital interfaces.
IP to Tel Tagging Source Dial Plan
Index
cconfigure voip > gateway routing
settings > ip-to-tel-tagging-src
[IP2TelTaggingSourceDialPlanIndex]
Defines the Dial Plan index in the Dial Plan file for calling
prefix tags for representing calling number prefixes in Inbound
Routing rules.
The valid values are 0 to 7, where 0 denotes PLAN1, 1
denotes PLAN2, and so on. The default is -1 (i.e., no dial plan
file used).
For more information on t
his feature, see Dial Plan Prefix Tags
for IP-to-Tel Routing on page 843.
Note: The parameter is applicable only to digital interfaces.
etsi-diversion
[EnableETSIDiversion]
Determines the method in which the Redirect Number is sent
to the Tel side.
[0] = (Default) Q.931 Redirecting Number Information
Element (IE).
[1] = ETSI DivertingLegInformation2 in a Facility IE.
Add CIC
configure voip > gateway
manipulation settings > add-cic
[AddCicAsPrefix]
Determines whether to add the Carrier Identification Code
(CIC) as a prefix to the destination phone number for IP-to-Tel
calls. When the parameter is enabled, the 'cic' parameter in
the incoming SIP INVITE can be used for IP-to-Tel routing
decisions. It routes the call to the appropriate Trunk Group
based on the parameter's value.
[0] No (default)
[1] Yes
For digital interfaces: The SIP 'cic' parameter enables the
transmission of the 'cic' parameter from the SIP network to the
ISDN. The 'cic' parameter is a three- or four-digit code used in
routing tables to identify the network that serves the remote
user when a call is routed over many different networks. The
'cic' parameter is carried in the SIP INVITE and maps to the
ISDN Transit Network Selection Information Element (TNS IE)
in the outgoing ISDN Setup message (if the EnableCIC
parameter is set to 1). The TNS IE identifies the requested
transportation networks and allows different providers equal
access support, based on customer choice.
For example, as a result of receiving the below INVITE, the
destination number after number manipulation is
cic+167895550001:
INVITE
sip:5550001;cic=+16789@172.18.202.60:5060;user=phone
SIP/2.0
Note: After the cic prefix is added, the IP-to-Tel Routing table
can be used to route this call to a specific Trunk Group. The
Destination Number IP to Tel Manipulation table must be used
to remove this prefix before placing the call to the ISDN.
[FaxReroutingMode] Enables the re-routing of incoming Tel-to-IP calls that are
identified as fax calls. If a CNG tone is detected on the Tel
side of a Tel-to-IP call, the device adds the string, "FAX" as a
To Next Page
Loading...
