Version 7.2 1309 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
a=inactive) between the user agents are different
and synchronization is required.
[1] Enable = Media synchronization is performed if
the media, including RTP mode or any other media
such as coders, is different and has not been
negotiated between the user agents.
[2] Never = Media synchronization is never
performed.
configure voip > sbc settings >
sbc-remove-sips-non-sec-transp
[SBCRemoveSIPSFromNonSecuredTranspo
rt]
Defines the SIP headers for which the device replaces
“sips:” with “sip:” in the outgoing SIP-initiating dialog
request (e.g., INVITE) when the destination transport
type is unsecured (e.g., UDP). (The “sips:” URI
scheme indicates secured transport, for example,
TLS.)
[0] = (Default) The device replaces “sips:” with
“sip:” for the Request-URI and Contact headers
only (and retains “sips:” for all other headers).
[1] = The device replaces “sips:” with “sip:” for the
Request-URI, Contact, From, To, P-Asserted, P-
Preferred, and Route headers.
SBC Fax Detection Timeout
configure voip > sbc settings > sbc-fax-
detection-timeout
[SBCFaxDetectionTimeout]
Defines the duration (in seconds) for which the device
attempts to detect fax (CNG tone) immediately upon
the establishment of a voice session. The interval
starts from the establishment of the voice call.
The valid value is 1 to any integer. The default is 10.
The feature applies to faxes that are sent immediately
after the voice channel is established (i.e., after 200
OK).
You can configure the handling of fax negotiation by
the device for specific calls, using IP Profiles
configured in the IP Profiles table (see the
IpProfile_SBCRemoteRenegotiateOnFaxDetection
parameter in Configuring IP Profiles on page 436).
Admission Control Table
Admission Control
configure voip > sbc sbc-admission-control
[SBCAdmissionControl]
Defines Call Admission Control (CAC) rules.
The format of the ini file table parameter is as follows:
[SBCAdmissionControl]
FORMAT SBCAdmissionControl_Index =
SBCAdmissionControl_AdmissionControlName,
SBCAdmissionControl_LimitType,
SBCAdmissionControl_IPGroupName,
SBCAdmissionControl_SRDName,
SBCAdmissionControl_SIPInterfaceName,
SBCAdmissionControl_RequestType,
SBCAdmissionControl_RequestDirection,
SBCAdmissionControl_Limit,
SBCAdmissionControl_LimitPerUser,
SBCAdmissionControl_Rate,
SBCAdmissionControl_MaxBurst,
SBCAdmissionControl_Reservation;
[\SBCAdmissionControl]
To Next Page
Loading...
