User's Manual 1330 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
For more information, see 'Configuring HTTP Interfaces' on page
300.
HTTP Proxy Services Table
HTTP Proxy Services
configure network >
http-proxy http-proxy-
serv
[HTTPProxyService]
Defines HTTP Proxy based services.
The format of the ini file table parameter is as follows:
[ HTTPProxyService ]
FORMAT HTTPProxyService_Index =
HTTPProxyService_ServiceName,
HTTPProxyService_ListeningInterface,
HTTPProxyService_URLPrefix,
HTTPProxyService_KeepAliveMode;
[ \HTTPProxyService ]
For more information, see 'Configuring HTTP Proxy Services' on
page 302.
HTTP Proxy Hosts Table
HTTP Proxy Hosts
configure network >
http-proxy http-proxy-
host
[HTTPProxyHost]
Defines HTTP Proxy hosts. The table is a "child" of the HTTP Proxy
Services table (HTTPProxyService). An HTTP Proxy Host
represents the HTTP-based managed equipment (e.g., IP Phone).
The format of the ini file table parameter is as follows:
[ HTTPProxyHost ]
FORMAT HTTPProxyHost_Index =
HTTPProxyHost_HTTPProxyServiceId,
HTTPProxyHost_HTTPProxyHostId,
HTTPProxyHost_NetworkInterface, HTTPProxyHost_IpAddress,
HTTPProxyHost_Protocol, HTTPProxyHost_Port,
HTTPProxyHost_TLSContext, HTTPProxyHost_VerifyCert;
[ \HTTPProxyHost ]
For more information, see 'Configuring HTTP Proxy Hosts' on page
303.
EMS Services Table
EMS Services
configure network >
http-proxy ems-serv
[EMSService]
Defines an HTTP-based EMS Service so that the device can act as
an HTTP Proxy that enables AudioCodes EMS to manage
AudioCodes equipment (such as IP Phones) over HTTP when the
equipment is located behind NAT (e.g., in the LAN) and EMS is
located in a public domain (e.g., in the WAN).
The format of the ini file table parameter is as follows:
[ EMSService ]
FORMAT EMSService_Index = EMSService_ServiceName,
EMSService_PrimaryServer, EMSService_SecondaryServer,
EMSService_DeviceLoginInterface, EMSService_EMSInterface;
[ \EMSService ]
For more information, see 'Configuring an HTTP-based EMS
Service' on page 305.