Version 7.2 243 Mediant 800B Gateway & E-SBC
User's Manual 15. Services
4. Click Apply, and then save your settings to flash memory.
Table 15-6: SIP Recording Rules Table Parameter Descriptions
Parameter Description
General
Index
[SIPRecRouting_Index]
Defines an index number for the new table record.
Recorded IP Group
recorded-ip-group-name
[SIPRecRouting_RecordedIPGroupName]
Defines the IP Group participating in the call and
the recording is done on the leg interfacing with
this IP Group. To configure IP Groups, see
'Configuring IP Groups' on page 365.
By default, all IP Groups are defined (Any).
Note:
The parameter is mandatory.
For an SBC RTP-SRTP session, the recorded
IP Group must be set to the RTP leg if
recording is required to be RTP, or set to the
SRTP leg if recording is required to be SRTP.
Recorded Source Prefix
recorded-src-prefix
[SIPRecRouting_RecordedSourcePrefix]
Defines calls to record based on source number or
URI.
By default, all source numbers or URIs are defined
(*).
Recorded Destination Prefix
recorded-dst-prefix
[SIPRecRouting_RecordedDestinationPrefix]
Defines calls to record based on destination
number or URI.
By default, all destination numbers or URIs are
defined (*).
Peer IP Group
peer-ip-group-name
[SIPRecRouting_PeerIPGroupName]
Defines the peer IP Group that is participating in
the call.
By default, all IP Groups are defined (Any).
Peer Trunk Group ID
peer-trunk-group-id
[SIPRecRouting_PeerTrunkGroupID]
Defines the peer Trunk Group that is participating
in the call (applicable only to Gateway calls). To
configure Trunk Groups, see Configuring Trunk
Groups on page 517.
Caller
caller
[SIPRecRouting_Caller]
Defines which calls to record according to which
party is the caller.
[0] Both = (Default) Caller can be peer or
recorded side
[1] Recorded Party (in Gateway, IP-to-Tel call)
Peer Party (in Gateway, Tel-to-IP call)
Recording Server
To Next Page
Loading...
