AudioCodes Mediant 800B - Page 248

User's Manual 248 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
2. Click New; the following dialog box appears:
Figure 15-10: RADIUS Servers Table - Add Dialog Box
3. Configure a RADIUS server according to the parameters described in the table below.
4. Click Apply.
Table 15-7: RADIUS Servers Table Parameter Descriptions
Parameter Description
Index
[RadiusServers_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
IP Address
ip-address
[RadiusServers_IPAddress]
Defines the IP address of the RADIUS server (in dotted-
decimal
notation).
Authentication Port
auth-port
[RadiusServers_AuthenticationPort]
Defines the port of the RADIUS Authentication server for
authenticating the device with the RADIUS server. When set to
any value other than 0, the RADIUS server is used by the
device for RADIUS-based management-user login
authentication. When set to 0, RADIUS-based login
authentication is not implemented.
The valid value is 0 to any integer. The default is 1645.
Accounting Port
acc-port
[RadiusServers_AccountingPort]
Defines the port of the RADIUS Accounting server to where the
device sends accounting data of SIP calls as call detail records
(CDR). When set to any value other than 0, the RADIUS server
is used by the device for RADIUS-based accounting (CDR).
When set to 0, RADIUS-based accounting is not implemented.
The valid value is 0 to any integer. The default is 1646.
Shared Secret
shared-secret
[RadiusServers_SharedSecret]
Defines the shared secret (password) for authenticating the
device with the RADIUS server. This should be a cryptically
strong password. The shared secret is also used by the
RADIUS server to verify the authentication of the RADIUS
messages sent by the device (i.e., message integrity).
The valid value is up to 48 characters. By default, no value is
defined.