User's Manual 298 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
b. In the 'Quality Status Rate' field (RoutingServerQualityStatusRate), enter the rate (in
sec) at which the device sends QoS reports.
Figure 15-50: Enabling QoS-Based Routing via Routing Server
c. Click Apply.
2. Open the Remote Web Services table (see Configuring Remote Web Services on page 297
), and then for the Remote Web Service entry that you configured for the routing server, do
the following:
a. From the 'Type' drop-down list (HTTPRemoteServices_HTTPType), select QoS.
b. Click Apply.
3. Enable voice quality monitoring and RTCP XR, using the 'Enable RTCP XR' (VQMonEnable)
parameter (see Configuring RTCP XR on page 961).
Note: For media metrics calculations, the device's License Key must include voice
quality monitoring and RTCP XR.
To Next Page
Loading...
