Version 7.2 351 Mediant 800B Gateway & E-SBC
User's Manual 17. Control Network
Parameter Description
SBC Routing Policy
sbc-routing-policy-name
[SRD_SBCRoutingPolic
yName]
Assigns a Routing Policy to the SRD.
By default, no value is defined if you have configured multiple Routing
Policies. If you have configured only one Routing Policy, the device
assigns it to the SRD by default.
For more information on Routing Policies, see Configuring SBC Routing
Policy Rules on page 730.
Note:
If you have assigned a Routing Policy to a Classification rule that is
associated with the SRD, the Routing Policy assigned to the SRD is
ignored.
You can assign the same Routing Policy to multiple SRDs.
The parameter is applicable only to the SBC application.
Used By Routing Server
used-by-routing-server
[SRD_UsedByRoutingS
erver]
Enables the SRD to be used by a third-party routing server for call routing
decisions.
[0] Not Used (default)
[1] Used
For more information on the third-party routing server feature, see
'Centralized Third-Party Routing Server' on page 294.
Dial Plan
sbc-dial-plan-name
[SRD_SBCDialPlanNam
e]
Assigns a Dial Plan to the SRD. The device searches the Dial Plan for a
dial plan rule that matches the source number and if not found, for a rule
that matches the destination number. If a matching dial plan rule is found,
the rule's tag is used in the routing and/or manipulation processes as
source and/or destination tags.
To configure Dial Plans, see Configuring Dial Plans on page 751.
Registration
Max. Number of
Registered Users
max-reg-users
[SRD_MaxNumOfRegUs
ers]
Defines the maximum number of users belonging to the SRD that can
register with the device.
The default is -1, which means that the number of allowed user
registrations is unlimited.
Note: The parameter is applicable only to the SBC application.
User Security Mode
block-un-reg-users
[SRD_BlockUnRegUser
s]
Defines the blocking (reject) policy for incoming SIP dialog-initiating
requests (e.g., INVITE messages) from registered and unregistered users
belonging to the SRD.
[0] Accept All = (Default) Accepts requests from registered and
unregistered users.
[1] Accept Registered Users = Accepts requests only from users
registered with the device. Requests from users not registered are
rejected.
[2] Accept Registered Users from Same Source = Accepts requests
only from registered users whose source address is the same as that
registered with the device (during the REGISTER message process).
All other requests are rejected. The device verifies whether the IP
address and port are different only if the transport protocol is UDP;
otherwise, the device verifies only the IP address. The verification is
performed before any of the device's call handling processes (i.e.,
Classification, Manipulation and Routing).
Note:
The parameter is applicable only to calls belonging to User-type IP
To Next Page
Loading...
