AudioCodes Mediant 800B - Page 388

User's Manual 388 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
proxy-address
[ProxyIp_IpAddress]
can be defined as an IP address in dotted-decimal notation (e.g.,
201.10.8.1) or FQDN. You can also specify the port using the
following format:
 IPv4 address: <IP address>:<port> (e.g., 201.10.8.1:5060)
 IPv6 address: <[IPV6 address]>:<port> (e.g.,
[2000::1:200:200:86:14]:5060)
Note:
 When configured with an FQDN, you can configure the periodic
rate at which the device performs DNS queries to resolve the
FQDN into IP addresses. For more information, see the
ProxyIPListRefreshTime parameter.
 When configured with an FQDN, you can configure the method
(e.g., A-record) for resolving the domain name into an IP
address, using the 'DNS Resolve Method' parameter in this table
(see above).
 The device supports up to 30 DNS-resolved IP addresses. If the
DNS resolution provides more than this number, the device uses
the first 30 IP addresses in the received list and ignores the rest.
 For the SBC application: You can configure the device to use the
port indicated in the Request-URI of the incoming message,
instead of the port configured for the parameter. To enable this,
use the IPGroup_SBCRouteUsingRequestURIPort parameter for
the IP Group that is associated with the Proxy Set (Configuring
IP Groups on page 365).
Transport Type
transport-type
[ProxyIp_TransportType]
Defines the transport type for communicating with the proxy.
 [0] UDP
 [1] TCP
 [2] TLS
 [-1] = (Default) The transport type is according to the settings of
the global parameter, SIPTransportType.