Version 7.2 407 Mediant 800B Gateway & E-SBC
User's Manual 18. SIP Definitions
9. Click New; the following dialog box appears:
Figure 18-1: Call Setup Rules Table - Add Dialog Box
10. Configure a Call Setup rule according to the parameters described in the table below.
11. Click Apply, and then save your settings to flash memory.
Table 18-2: Call Setup Rules Parameter Descriptions
Parameter Description
General
Index
[CallSetupRules_Index]
Defines an index number for the new table record.
Note: Each rule must be configured with a unique index.
Rules Set ID
rules-set-id
[CallSetupRules_RulesSetID]
Defines a Set ID for the rule. You can define the same Set ID
for multiple rules to create a group of rules. You can configure
up to 10 Set IDs, where each Set ID can include up to 10 rules.
The Set ID is used to assign the Call Setup rules to a routing
rule in the routing table.
The valid value is 0 to 9. The default is 0.
Query Type
query-type
[CallSetupRules_QueryType]
Defines the type of query.
[0] None (default)
[1] LDAP = The Call Setup rule performs an LDAP query
with an LDAP server.
[2] Dial Plan = The Call Setup rule performs a query with
the Dial Plan.
To specify an LDAP server or Dial Plan, use the 'Query Target'
parameter (see below).
Query Target
query-target
[CallSetupRules_QueryTarget]
Defines one of the following, depending on the value
configured for the 'Query Type' parameter (above):
LDAP: Specifies an LDAP server (LDAP Server Group) on
which to perform an LDAP query for a defined search key.
To configure LDAP Server Groups, see Configuring LDAP
Server Groups on page 256.
Dial Plan: Specifies a Dial Plan (name) in which to search
for a defined search key. To configure Dial Plans, see
Configuring Dial Plans on page on page 751.
To Next Page
Loading...
