AudioCodes Mediant 800B - Page 452

User's Manual 452 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
[IpProfile_SBCVoiceQualityE
nhancement]

[0] Disable (default)
 [1] Enable
Note: The parameter is applicable only to the VoIPerfect feature (see
VoIPerfect on page 788).
Max Opus Bandwidth
sbc-max-opus-bandwidth
[IpProfile_SBCMaxOpusBW]
Defines the VoIPerfect mode of operation, which is based on the Opus
coder.
 0 = (Default) Managed Opus
 80000 = Smart Transcoding
Note: The parameter is applicable only to the VoIPerfect feature (see
VoIPerfect on page 788).
Quality of Service
RTP IP DiffServ
rtp-ip-diffserv
[IpProfile_IPDiffServ]
Defines the DiffServ value for Premium Media class of service (CoS)
content.
The valid range is 0 to 63. The default is 46.
Note: The corresponding global parameter is
PremiumServiceClassMediaDiffServ.
Signaling DiffServ
signaling-diffserv
[IpProfile_SigIPDiffServ]
Defines the DiffServ value for Premium Control CoS content (Call
Control applications).
The valid range is 0 to 63. The default is 40.
Note:
 The corresponding global parameter is
PremiumServiceClassControlDiffServ.
Jitter Buffer
Dynamic Jitter Buffer
Minimum Delay
jitter-buffer-minimum-delay
[IpProfile_JitterBufMinDelay]
Defines the minimum delay (in msec) of the device's dynamic Jitter
Buffer.
The valid range is 0 to 150. The default delay is 10.
For more information on Jitter Buffer, see Configuring the Dynamic
Jitter Buffer on page 207.
Note:
 The corresponding global parameter is DJBufMinDelay.
Dynamic Jitter Buffer
Optimization Factor
jitter-buffer-optimization-
factor
[IpProfile_JitterBufOptFactor]
Defines the Dynamic Jitter Buffer frame error/delay optimization factor.
The valid range is 0 to 12. The default factor is 10.
For more information on Jitter Buffer, see Configuring the Dynamic
Jitter Buffer on page 207.
Note:
 For data (fax and modem) calls, set the parameter to 12.
 The corresponding global parameter is DJBufOptFactor.
Jitter Buffer Max Delay
jitter-buffer-max-delay
[IpProfile_JitterBufMaxDelay]
Defines the maximum delay and length (in msec) of the Jitter Buffer.
The valid range is 150 to 2,000. The default is 250.
Voice
Echo Canceler
echo-canceller
[IpProfile_EnableEchoCance
ller]
Enables the device's Echo Cancellation feature (i.e., echo from voice
calls is removed).
 [0] Disable
 [1] Line (default)