AudioCodes Mediant 800B - Page 462

User's Manual 462 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
sbc-fax-coders-group-name
[IpProfile_SBCFaxCodersGr
oupName]
negotiation for the SIP entity associated with the IP Profile. To
configure Coder Groups, see Configuring Coder Groups on page 427.
Note:
 The parameter is applicable only if you set the
IpProfile_SBCFaxBehavior parameter to a value other than [0].
Fax Mode
sbc-fax-behavior
[IpProfile_SBCFaxBehavior]
Enables the device to handle fax offer-answer negotiations for the SIP
entity associated with the IP Profile.
 [0] As Is = (Default) Device forwards fax transparently, without
interference.
 [1] Handle always = Handle fax according to fax settings in the IP
Profile for all offer-answer transactions (including the initial
INVITE).
 [2] Handle on re-INVITE = Handle fax according to fax settings in
the IP Profile for all re-INVITE offer-answer transactions (except for
initial INVITE).
Note:
 The fax settings in the IP Profile include
IpProfile_SBCFaxCodersGroupName,
IpProfile_SBCFaxOfferMode, and IpProfile_SBCFaxAnswerMode.
Fax Offer Mode
sbc-fax-offer-mode
[IpProfile_SBCFaxOfferMod
e]
Defines the coders included in the outgoing SDP offer (sent to the
called "fax") for the SIP entity associated with the IP Profile.
 [0] All coders = (Default) Use only (and all) the coders of the
selected Coder Group configured using the
SBCFaxCodersGroupID parameter.
 [1] Single coder = Use only one coder. If a coder in the incoming
offer (from the calling "fax") matches a coder in the
SBCFaxCodersGroupID, the device uses this coder. If no match
exists, the device uses the first coder listed in the Coders Group ID
(SBCFaxCodersGroupID).
Note:
 The parameter is applicable only if you set the
IpProfile_SBCFaxBehavior parameter to a value other than [0].
Fax Answer Mode
sbc-fax-answer-mode
[IpProfile_SBCFaxAnswerM
ode]
Defines the coders included in the outgoing SDP answer (sent to the
calling "fax") for the SIP entity associated with the IP Profile.
 [0] All coders = Use matched coders between the incoming offer
coders (from the calling "fax") and the coders of the selected Coder
Group (configured using the SBCFaxCodersGroupID parameter).
 [1] Single coder = (Default) Use only one coder. If the incoming
answer (from the called "fax") includes a coder that matches a
coder match between the incoming offer coders (from the calling
"fax") and the coders of the selected Coder Group
(SBCFaxCodersGroupID, then the device uses this coder. If no
match exists, the device uses the first listed coder of the matched
coders between the incoming offer coders (from the calling "fax")
and the coders of the selected Coder Group.
Note:
 The parameter is applicable only if you set the
IpProfile_SBCFaxBehavior parameter to a value other than [0].
Remote Renegotiate on Fax
Detection
Enables local handling of fax detection and negotiation by the device
on behalf of the SIP entity associated with the IP Profile. This applies
to faxes sent immediately upon the establishment of a voice channel