AudioCodes Mediant 800B - Page 478

User's Manual 478 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Tel Profile Parameter Global Parameter
Note:
 The selected busy or reorder tone is according to the SIP
release cause code received from IP.
 The parameter is applicable to CAS.
 The parameter is also applicable to ISDN when the
PlayBusyTone2ISDN parameter is set to 2.
 The corresponding global parameter is
TimeForReorderTone.
Enable Voice Mail Delay
enable-voice-mail-delay
[TelProfile_EnableVoiceMailDelay]
Enables and disables voice mail services.
 [0] Disable
 [1] Enable (default)
The parameter is useful if you want to disable voice mail
services per Trunk Group to eliminate the phenomenon of call
delay on Trunks that do not implement voice mail when voice
mail is configured using the global parameter,
VoiceMailInterface.
Swap Tel To IP Phone Numbers
swap-teltoip-phone-numbers
[TelProfile_SwapTelToIpPhoneNumbers]
Enables the device to swap the calling and called numbers
received from the Tel side (for Tel-to-IP calls). The SIP INVITE
message contains the swapped numbers.
 [0] Disable (default)
 [1] Enable
Note: The corresponding global parameter is
SwapTEl2IPCalled&CallingNumbers.
IP2Tel CutThrough Call Behavior
ip2tel-cutthrough_call_behavior
[TelProfile_IP2TelCutThroughCallBehavior]
Enables the Cut-Through feature, which allows phones connected to the
device’s FXS ports to automatically receive IP calls (if there is no other
currently active call) even when in off-hook state (and no call is currently
active).
 [0] Disable = Calls can only be received in on-hook state.
 [1] CutThrough = (Enabled with tones) Calls can be received
in off-hook state. When the IP side ends the call, the device
can play a reorder tone to the Tel side for a user-defined
duration (configured by the
CutThroughTimeForReorderTone parameter). Once the
tone stops playing, the FXS phone is ready to automatically
answer another incoming IP call in off-hook state. A waiting
call is automatically answered by the device when the
current call is terminated (and if the EnableCallWaiting
parameter is configured to 1).
 [2] CutThrough + Paging = (Enabled and no tones) Calls
can be received in off-hook state, but no tones are played
(before or after the call) in off-hook state. The option is
useful for paging calls, which provides a one-way voice path
from the paging phone to the paged phones (FXS phones).
Note:
 The parameter is applicable only to FXS interfaces.
 The corresponding global parameter is CutThrough.
Voice
DTMF Volume
dtmf-volume
[TelProfile_DtmfVolume]
Defines the DTMF gain control value (in decibels) to the Tel
side.
The valid range is -31 to 0 dB. The default is -11 dB.