AudioCodes Mediant 800B - Page 481

Version 7.2 481 Mediant 800B Gateway & E-SBC
User's Manual 20. Coders and Profiles
Tel Profile Parameter Global Parameter
"KP911ST" (denotes *911#).
3) The device waits for polarity reversal change from
normal to reverse for an interval of 2,000 msec.
4) Upon detection of a polarity reversal change, the
device dials the DTMF (or MF) digits of the calling party
(number that dialed 911) in the format "KP<ANI>ST"
(*ANI#), where ANI is the calling number from the
INVITE. If no polarity reversal, the FXO goes idle.
For example: (Wink) KP911ST (Polarity Change)
KP02963700ST
Note: The Enable911PSAP parameter must be set to 1.
Note:
 For FXS interfaces, the EnableReversalPolarity and
PolarityReversalType parameters must be configured to 1.
 The parameter is applicable to FXS and FXO interfaces.
 The corresponding global parameter is EnableDIDWink.
Enable 911 PSAP
enable-911-psap
[TelProfile_Enable911PSAP]
Enables the support for the E911 DID protocol, according to the
Bellcore GR-350-CORE standard. The protocol defines
signaling between E911 Tandem Switches and the PSAP,
using analog loop-start lines. The device's FXO interface can
be used instead of an E911 switch, connected directly to PSAP
DID loop-start lines.
 [0] Disable (default)
 [1] Enable
Note:
 The parameter is applicable only to FXO interfaces.
 The corresponding global parameter is Enable911PSAP.
IP Settings
Coders Group
coders-group
[TelProfile_CodersGroupName]
Assigns a Coder Group, which defines audio (voice) coders
that can be used for the endpoints associated with the Tel
Profile.
To configure Coders Groups, see 'Configuring Coder Groups'
on page 427.
RTP IP DiffServ
rtp-ip-diffserv
[TelProfile_IPDiffServ]
Defines the DiffServ value for Premium Media class of service
(CoS) content.
The valid range is 0 to 63. The default is 46.
Note:
 For more information on DiffServ, see 'Configuring Class-of-
Service QoS' on page 166.
 The corresponding global parameter is
PremiumServiceClassMediaDiffServ.
Signaling DiffServ
signaling-diffserv
[TelProfile_SigIPDiffServ]
Defines the DiffServ value for Premium Control CoS content
(Call Control applications).
The valid range is 0 to 63. The default is 40.
Note:
 For more information on DiffServ, see 'Configuring Class-of-
Service QoS' on page 166.
 The corresponding global parameter is