User's Manual 606 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
The following example demonstrates three-way conferencing using the device's local, on-
board conferencing feature. In the example, telephone "A" connected to the device
establishes a three-way conference call with two remote IP phones, "B" and "C":
1. A establishes a regular call with B.
2. A places B on hold, by pressing the telephone's flash-hook button and the number "1"
key.
3. A hears a dial tone and then makes a call to C.
4. C answers the call.
5. A establishes a three-way conference call with B and C, by pressing the flash-hook
button and the number "3" key.
To configure three-way conferencing:
1. Open the Supplementary Services Settings page (Setup menu > Signaling & Media
tab > Gateway folder > DTMF & Supplementary > Supplementary Services
Settings).
Figure 27-9: Configuring Three-way Conferencing
2. From the 'Enable 3-Way Conference' drop-down list (Enable3WayConference), select
Enable.
3. From the '3-Way Conference Mode' drop-down list (3WayConferenceMode), select
the three-way conference mode (e.g, On Board).
4. For On Board mode:
• In the 'Max. 3-Way Conference' field (MaxInBoardConferenceCalls), enter the
maximum number of simultaneous, on-board three-way conference calls.
•
5. In the 'Conference ID' field (ConferenceID), enter the Conference Identification string.
6. The valid value is a string of up to 16 characters. The default is "conf".
7. Configure one of the following for how the device recognizes a three-way conference
request:
• In the 'Establish Conference Code' field (ConferenceCode), enter the DTMF digit
pattern (e.g., hook flash) that upon detection generates the conference call.
• From the 'Flash Keys Sequence Style' drop-down list (FlashKeysSequenceStyle),
select Sequence 1 or Sequence 2 to use the flash + 3 key-combination to create
the three way conference call.
8. Click Apply and then reset the device with a save-to-flash for your settings to take
effect.
To Next Page
Loading...
