AudioCodes Mediant 800B - Page 726

User's Manual 726 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
• IP Group for the third IP PBX ("Type" and "Port" tags are later used to identify the
IP PBX and assign it a local UDP port 6003 on the leg interfacing with the proxy
server):
General
Index
3
Name
PBX-3
Type
Server
SBC Advanced
Tags
Type=PBX;Port=6003
• IP Group for the proxy server ("Type" tag is later used to identify proxy server):
General
Index
4
Name
ITSP
Type
Server
SBC Advanced
Tags
Type=ITSP
7. Open the Call Setup Rules table (see Configuring Call Setup Rules on page 404), and
then configure the following Call Setup rules:
• Uses the value of the "Type" tag name, configured in the IP Group's 'Tags'
parameter, as the source tag:
General
Index
1
Rule Set ID
1
Action
Action Subject
srctags.Type
Action Type
Modify
Action Value
param.ipg.src.tags.Type
• If the source tag name "Type" equals "PBX" (i.e., SIP message from an IP Group
belonging to one of the IP PBXs), then use the value of the "Port" tag name,
configured in the 'Tags' parameter of the classified IP Group, as the local UDP
port on the leg interfacing with the proxy server for messages sent to the proxy
server:
General
Index
2
Rule Set ID
1
Condition
srctags.Type=='PBX'
Action