User's Manual 742 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Least Cost Routing (LCR), you need to configure these settings for the Routing Policy
(regardless of the number of Routing Policies employed). For more information on Routing
Policies, see 'Configuring SBC Routing Policy Rules' on page 730.
Note: The IP Groups table can be used to configure a host name that overwrites the
received host name. This manipulation can be done for source and destination IP
Groups (see 'Configuring IP Groups' on page 365).
The following procedure describes how to configure Inbound Manipulation rules through
the Web interface. You can also configure it through ini file (IPInboundManipulation) or CLI
(configure voip > sbc manipulation ip-inbound-manipulation).
To configure an Inbound Manipulation rule:
1. Open the Inbound Manipulations table (Setup menu > Signaling & Media tab > SBC
folder > Manipulation > Inbound Manipulations).
2. Click New; the following dialog box appears:
Figure 35-2: Inbound Manipulations Table - Add Dialog Box
3. Configure the Inbound Manipulation rule according to the parameters described in the
table below.
4. Click Apply.
Table 35-1: Inbound Manipulations Table Parameter Descriptions
Parameter Description
Routing Policy
routing-policy-name
[IPInboundManipulation_Rout
Assigns an Routing Policy to the rule. The Routing Policy associates
the rule with an SRD(s). The Routing Policy also defines default LCR
settings as well as the LDAP servers if the routing rule is based on
LDAP routing (and Call Setup Rules).
To Next Page
Loading...
