AudioCodes Mediant 800B - Page 746

User's Manual 746 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
 To configure Outbound Manipulation rules:
1. Open the Outbound Manipulations table (Setup menu > Signaling & Media tab >
SBC folder > Manipulation > Outbound Manipulations).
2. Click New; the following dialog box appears:
Figure 35-3: Outbound Manipulations Table- Add Dialog Box
3. Configure an Outbound Manipulation rule according to the parameters described in
the table below.
4. Click Apply.
Table 35-2: Outbound Manipulations Table Parameter Description
Parameter Description
Routing Policy
routing-policy-name
[IPOutboundManipulation_Rou
tingPolicyName]
Assigns a Routing Policy to the rule. The Routing Policy associates
the rule with an SRD(s). The Routing Policy also defines default
LCR se
ttings as well as the LDAP servers if the routing rule is based
on LDAP routing (and Call Setup Rules).
If only one Routing Policy is configured in the Routing Policies table,
the Routing Policy is automatically assigned. If multiple Routing
Policies are configured, no value is assigned.
To configure Routing Policies, see 'Configuring SBC Routing Policy
Rules' on page 730.
Note: The parameter is mandatory.
General
Index
[IPOutboundManipulation_Inde
x]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
manipulation-name
[IPOutboundManipulation_Man
ipulationName]
Defines a descriptive name, which is used when associating the row
in other tables.
The valid value is a string of up to 40 characters. By default, no
value is defined.