Version 7.2 763 Mediant 800B Gateway & E-SBC
User's Manual 36. Configuring Dial Plans
Parameter Index 0 Index 1
Tag Country=England;City=London Holland;City=Amsterdam;Country=Belgium
The following displays the configuration in the Web interface of the Dial Plan rule for Index
0:
Figure 36-8: Dial Plan configuration Example
2. In the IP Groups table, configure your IP Groups. Make sure that you assign the
source IP Group with the Dial Plan that you configured in Step 1 and that you
configure each destination IP Group with one of the required Dial Plan tags. If the tag
has a value, include it as well. In our example, we will configure three IP Groups:
Parameter Index 0 Index 1 Index 2
Name HQ ENG BEL
Dial Plan Dial Plan 1 - -
Tags - Country=England Country=Belgium
3. In the IP-to-IP Routing table, configure a routing rule where the 'Destination Type'
parameter is configured to Destination Tag and the 'Routing Tag Name' to one of
your Dial Plan tags. In our example, the tag "Country" is used:
Parameter Index 0
Name Europe
Source IP Group HQ
Destination Type Destination Tag
Routing Tag Name Country
Note:
• Please adhere to the following regarding the 'Tag' parameter in the Dial Plan Rule
table:
√ Only one tag name without a value can be configured. In the above example,
"Holland" is the tag name without a value. If an additional tag name is
configured, for example, "Holland;France", the setting is invalid.
√ Tag names with values (i.e., name=value) must be unique within a Dial Plan
To Next Page
Loading...
