AudioCodes Mediant 800B User Manual

User's Manual 814 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Index Source IP
Source
Port
Prefix
Length
Start
Port
End Port Protocol
Use
Specific
Interface
Interface
Name
Action
Upon
Match
Packet
Size
Byte
Rate
Byte
Burst
12
10.31.4.61 0 32 2442 2442 tcp Enable HA_IF Allow 0 0 0
13
10.31.4.62 2442 32 0 65535 tcp Enable HA_IF Allow 0 0 0
14
10.31.4.61 2442 32 0 65535 tcp Enable HA_IF Allow 0 0 0
15
10.31.4.62 0 32 2442 2442 tcp Enable HA_IF Allow 0 0 0
16
10.31.4.61 80 32 0 65535 tcp Enable HA_IF Allow 0 0 0
17
10.31.4.62 80 32 0 65535 tcp Enable HA_IF Allow 0 0 0
18
10.31.4.61 670 32 670 670 udp Enable HA_IF Allow 0 0 0
19
10.31.4.61 680 32 680 680 udp Enable HA_IF Allow 0 0 0
20
10.31.4.62 670 32 670 670 udp Enable HA_IF Allow 0 0 0
21
10.31.4.62 680 32 680 680 udp Enable HA_IF Allow 0 0 0
22
0.0.0.0 0 0 0 65535 Any Disable -- Block 0 0 0
Note:
• The index numbers in the table above may change according to your specific
allow and block rules.
• The last rule (Index 22) is an example of a blocking traffic rule (blocks all other
traffic).
• Configure the firewall on the Active device. This configuration is automatically
applied to the Redundant device.
• If you have an external firewall located between the Active and the Redundant HA
Maintenance interfaces, you must open (allow) the same port ranges as
configured in the table above, on that external firewall.

AudioCodes Mediant 800B Specifications

General

Brand	AudioCodes
Model	Mediant 800B
Category	Gateway
Language	English