User's Manual 88 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Note:
• Configure the IP address of the computer from which you are currently logged into
the device as the first authorized IP address in the Access List. If you configure
any other IP address, access from your computer will be immediately denied.
• If you configure network firewall rules in the Firewall table (see 'Configuring
Firewall Rules' on page 175), you must configure a firewall rule that permits traffic
from IP addresses configured in the Access List table.
 To add IP addresses to the Access List:
1. Open the Access List table (Setup menu > Administration tab > Web & CLI folder >
Access List).
Figure 6-36: Access List - Adding IP Address
2. In the 'Add an authorized IP address' field, configure an IP address, and then click
Add New Entry; the IP address is added to the table.
Figure 6-37: Web & Telnet Access List Table
If you have configured IP addresses in the Access List and you no longer want to restrict
access to the management interface based on the Access List, delete all the IP addresses
in the table, as described in the following procedure.
Note: When deleting all the IP addresses, make sure that you delete the IP address
of the computer from which you are currently logged into the device, last; otherwise,
access from your computer will be immediately denied.
 To delete an IP address from the Access List:
1. Select the Delete Row check box corresponding to the IP address that you want to
delete.
2. Click Delete Selected Addresses.
To Next Page
Loading...
Need help?
General
