User's Manual 954 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
To view SBC CDR history:
Web: Open the SBC CDR History table (Monitor menu > Monitor tab > VoIP Status
folder > SBC CDR History).
Figure 60-6: SBC CDR History Table
CLI:
• All CDR history:
# show voip calls history sbc
• CDR history for a specific SIP session ID:
# show voip calls history sbc <session ID>
Table 60-7: SBC CDR History Table
Field Description
Call End Time
Displays the time at which the call ended. The time is displayed in the
format, hh:mm:ss, where hh is the hour, mm the minutes and ss the
seconds (e.g., 15:06:36).
IP Group
Displays the IP Group of the leg for which the CDR was generated.
Caller
Displays the phone number (source URI user@host) of the party who
made the call.
Callee
Displays the phone number (destination URI user@host) of the party to
whom the call was made.
Direction
Displays the direction of the call:
"Incoming"
"Outgoing"
Remote IP
Displays the IP address of the call party. For an "Incoming" call, this is
the source IP address; for an "Outgoing" call, this is the destination IP
address.
Duration
Displays the duration of the call, displayed in the format hh:mm:ss,
where hh is hours, mm minutes and ss seconds. For example, 00:01:20
denotes 1 minute and 20 seconds.
Termination Reason
Displays the reason for the call being released (ended). For example,
"NORMAL_CALL_CLEAR" indicates a normal termination.
Session ID
Displays the SIP session ID of the call.
To Next Page
Loading...
