User's Manual 980 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
CDR Field Description
(CDR Report
Type)
SigTransportType
SIP signaling transport type (UDP, TCP, or TLS) All
TxRTPIPDiffServ
Media IP DiffServ "CALL_END"
TxSigIPDiffServ
Signaling IP DiffServ All
LocalRFactor
Local R-factor
Note: If the RTCP XR feature is unavailable (not licensed or
disabled), this R-factor VoIP metric is not provided. Instead,
the device sends the CDR field with the value 127, meaning
that information is unavailable.
"CALL_END"
RemoteRFactor
Remote R-factor
Note: If the RTCP XR feature is unavailable (not licensed or
disabled), this R-factor VoIP metric is not provided. Instead,
the device sends the CDR field with the value 127, meaning
that information is unavailable.
"CALL_END"
LocalMosCQ
Local MOS for conversation quality "CALL_END"
RemoteMosCQ
Remote MOS for conversation quality "CALL_END"
SigSourcePort
SIP source port All
SigDestPort
SIP destination port All
MediaType
Media type - audio, video, or text "CALL_END"
AMD Information relating to the Automatic Machine Detection
(AMD) feature:
 "V": voice
 "A": answer machine
 "S": silence
 "U": unknown
"CALL_END"
% Information relating to AMD that shows the success that the
answering type (probability) was correctly detected
"CALL_END"
SIPTrmReason
SIP call termination reason (BYE, CANCEL, or SIP error
codes, e.g., 404)
"CALL_END"
SipTermDesc
Description of SIP termination reason:
 SIP Reason header, if exists, for example: SIP
;cause=200 ;text="Call completed elsewhere".
 If no SIP Reason header exists, the description is taken
from the reason text, if exists, of the SIP response code,
for example: "417 Unknown Resource-Priority".
 If no reason text exists in the SIP response code, the
description is taken from an internal SIP response
mapping mechanism. For example, if the device receives
a SIP response "422", it sends in the CDR "422 Session
Interval Too Small method" as the description.
"CALL_END"
PstnTermReason
Q.850 protocol termination reason (0-127). "CALL_END"
To Next Page
Loading...
Need help?
General
