Automationdirect.com DL05 - Handheld Programmer; I;O Selection Quick Chart

Getting Started
1–5
Getting Started
DirectSOFT universally supports the DirectLOGIC CPU families. This means you
can use the full version of DirectSOFT to program DL05, DL105, DL205, DL305,
DL405 or any new CPUs we may add to our product line. (Upgrade software may be
required for new CPUs as they become available.). A separate manual discusses
DirectSOFT programming software. DirectSOFT version 2.4 or later is needed to
program the DL05.
All DL05 Micro PLCs have built-in programming ports for use with the handheld
programmer (D2–HPP), the same programmer used with the DL105 and DL205
families. The handheld programmer can be used to create, modify and debug your
application program. A separate manual discusses the Handheld Programmer. Only
D2–HPPs with firmware version 1.09 or later will program the DL05.
I/O Selection Quick Chart
The eight versions of the DL05 have Input/Output circuits which can interface to a
wide variety of field devices. In several instances a particular Input or Output circuit
can interface to either DC or AC voltages, or both sinking and sourcing circuit
arrangements. Check this chart carefully to find the proper DL05 Micro PLC to
interface to the field devices in your application.
DL05
PtN b
INPUTS OUTPUTS
Part Number
I/O type /
commons
Sink /
Source
Voltage Ranges
I/O type /
commons
Sink /
Source
Voltage / Current
Ratings
D0–05AR AC / 2 – 90 – 120 VAC Relay / 2 Sink or
Source
6 – 27 VDC, 2A *
6 – 240 VAC, 2A *
D0–05DR DC / 2 Sink or
Source
12 – 24 VDC Relay / 2 Sink or
Source
6 – 27 VDC, 2A *
6 – 240 VAC, 2A *
D0–05AD AC / 2 – 90 – 120 VAC DC / 1 Sink 6 – 27 VDC, 0.5A (Y0–Y2)
6 – 27 VDC, 1.0A (Y3–Y5)
D0–05DD DC / 2 Sink or
Source
12 – 24 VDC DC / 1 Sink 6 – 27 VDC, 0.5A (Y0–Y2)
6 – 27 VDC, 1.0A (Y3–Y5)
D0–05AA AC / 2 – 90 – 120 VAC AC / 2 – 17 – 240 VAC, 47 – 63 Hz
0.5A *
D0–05DA DC / 2 Sink or
Source
12 – 24 VDC AC / 2 – 17 – 240 VAC, 47 – 63 Hz
0.5A *
D0–05DR–D DC / 2 Sink or
Source
12 – 24 VDC Relay / 2 Sink or
Source
6 – 27 VDC, 2A *
6 – 240 VAC, 2A *
D0–05DD–D DC / 2 Sink or
Source
12 – 24 VDC DC / 1 Sink 6 – 27 VDC, 0.5A (Y0–Y2)
6 – 27 VDC, 1.0A (Y3–Y5)
* See Chapter 2 Specifications for your particular DL05 version.
Handheld
Programmer